注册 登录  
 加关注
   显示下一条  |  关闭
温馨提示!由于新浪微博认证机制调整,您的新浪微博帐号绑定已过期,请重新绑定!立即重新绑定新浪微博》  |  关闭

未来的天空

繁星的天空

 
 
 

日志

 
 

自制MP3播放器  

2005-07-17 07:00:23|  分类: 维修地狱 |  标签: |举报 |字号 订阅

  下载LOFTER 我的照片书  |
简述:此款名为yampp-7型MP3播放器,用了一片Nokia3310手机的LCD显示屏来显示操作,使用一片FT8U245 USB芯片!能使用多种小型Flash卡和多媒体卡作为歌曲文件存储器!


yampp7 is a new portable MP3 player that uses Compact Flash or MultiMedia cards for storage of songs. You'll get about 1 minute of playing time per MB on the memory card, if your songs are 128 kbps.
The player is pretty small and the PCB has been designed to fit into a Teko "Soap" box.
It features a 84*48 pixel graphical LCD display, similar to the displays used on Nokia 3310 cell phones.

It's designed to operate from rechargable battery cells, either from a single 3.6V Li-Ion cell (recommended), or from 3*1.2V Ni-Mh cells. With a 600 mA Li-Ion cell, the playing time is about 12 hours, but you can find Li-Ion cells up to 1200 mAh that will fit in the player, extending the playing time to about 24 hours

It's intended to be used with replacement Li-Ion cells for Mobile Phones, making it easy (and relatively cheap) to find a suitable cell. (I use mine with a cell for a Motorola V3688 Phone).


 

It also features a USB interface for fast downloading of songs to the memory card, and for firmware updates


 

The player uses a special filesystem called YADL (Yampp Advanced Disk Layout), which maximizes the capacoty of the memory card.
It is playlist based and give the player a powerful but easy to use user interface

Processor
The central part of the yampp-7 player is the Atmel mega161 CPU. It's like a big-brother to the classic 8515 CPU that was used on the original yampp-3.
It has 16 kB Flash and 1024 bytes internal SRAM, both double as much as on the 8515.
It also features a bootloader option. This is been used in yampp-7, where it is now possible to download new firmware over the USB link


 

USB
The USB link is controlled by a FT8U245BM chip from FTDI. This is a VERY easy to use USB chip, which basically looks like a simple 8-bit buffer (hence the name). There's no need for implementing any specific USB code in the player, to communicate over the USB link, you just read and write data directly to the chip.
Two status pins indicate if there's any data in the receive buffer, and if the transmitter queue is empty.
The USB chip is memorymapped and occupies a single address in the CPU address space.
Some discrete circuitry is added to the USB chip to enable it to startup in the correct mode, and to handle the power on reset and Soft-Connect feature.


 

Li-Ion charger
A Maxim MAX1811 chip is added for handling the charging of the Li-Ion cell.(Ni-Mh cells can also be used in the player, in this case, the MAX1811 is replaced by a diode and a resistor).
The MAX chip is a special USB to Li-Ion charger, and it controls the relatively complicated charge sequence to the Li-Ion cell.
The Li-Ion cell (or Ni-Mh cells), supply 3.6V to the other components.


 

Memory card Interface
The player can be used with either a Compact Flash card or a MultiMedia Card.
The Compact Flash (CF) interface is pretty similar to a standard ATA interface. The nice thing about it, is that it can run in 8-bit mode, making it very simple to interface to a microprocessor.
In the yampp-7, the CF interface is mapped directly into the memorymap of the processor. To control the CF card and to read/write data, the standard ATA register bank of is used, and address bits A8-A11 is used to select the register.
The MultiMedia Interface is a serial interface with an SPI bus. As the mega161 already has such a bus, the MultiMedia card is simply hooked onto this bus, with a single address line used as chip select.


 

Address decoding
To simplify the addressing of the CF card and USB interface, a 74HC00 is used to gate the RD and WR signals to the USB chip depending on the state of address line A15. With this, the USB chip will be located at address 0x8000, and the CF card's registers are located at 0x1000 to 0x1F00.


 

MP3 Decoder
The MP3 decoder is, as on other yampp's the VS1001K chip from VLSI. It's an easy to use decoder with a built in DAC. It's clocked from a 12.288 MHz crystal, enabling bitrates up to 256k bps.
It also has a built in headphone amplifier.


 

Player control
The player is controlled with 4 pushbuttons. One of these is connected to the ICP input of the CPU, which can generate an interrupt to the CPU. When the player is stopped, it enters power-down mode after 1 minute. The interrupt from the button can then be used to wakeup the CPU from the low-power sleep mode.
All buttons have two functions, one is reached by a short press on the button, and the other by holding down the button. Depending on player state, the buttons control various functio



 

Partslist  

Part  value  Package
--------  ------------- -----------------
R1,R6  10k             R0805
R2,R3      100R            R0805 *
R4         1M              R0805
R5,R8,R11  4k7             R0805
R7        1k5            R0805
R10  2k2  R0805
R12  470  R0805
R13        33k            R0805
R14,R15    27             R0805
R16  51k  R0805
C1,C6,C7   100nF  C0805
C9-C11     100nF  C0805
C2-C5      33pF            C0805
C8     10uF/16  ELNA_RV2_4
C14     10uF/16 Tantal ! C6032
C15     1uF/16 Tantal C3528
C12,C13    100uF/10      ELNA_RV2_63
D1         BAS32           SOD80 *
T2         BC817           SOT23
IC1        ATmega161L      TQFP44
IC2        VS1001K         SOIC-28
IC4        74HC00D         SO14
IC5        MAX1811         SO8 **
IC6        FT8U245BM       QFP32
Q1         4.000MHz        HC49U-V Crystal
Q2         12.288MHz       HC49U-V Crystal
Q3         6.00MHz         Ceramic Resonator
J1         Compact Flash Connector
J2         LCD/Programming Angled Connector 2*5 2mm
SH1       MultiMedia Card Connector
X1         Headphones      3.5mm Jack
X2         USB Connector   Type787780
SW1-SW4  ALPS Type SKHHLQ pushbutton

* = only used with Ni-Mh cells
** = only used with Li-Ion cells  

 

  评论这张
 
阅读(1243)| 评论(1)
推荐 转载

历史上的今天

评论

<#--最新日志,群博日志--> <#--推荐日志--> <#--引用记录--> <#--博主推荐--> <#--随机阅读--> <#--首页推荐--> <#--历史上的今天--> <#--被推荐日志--> <#--上一篇,下一篇--> <#-- 热度 --> <#-- 网易新闻广告 --> <#--右边模块结构--> <#--评论模块结构--> <#--引用模块结构--> <#--博主发起的投票-->
 
 
 
 
 
 
 
 
 
 
 
 
 
 

页脚

网易公司版权所有 ©1997-2017